Call For Free Estimate (916)-360-7572

DIY Plumbing

Root Details In Plumber In Sacramento – An Update

Posted by on Dec 23, 2015 in DIY Plumbing

Tips on how to Replace a Faucet Maybe youíve wondered on how to change a faucet at some time. It isnít as challenging as you may have imagined. A few hours and some basic equipment are all it takes. When properly changed, a new faucet eliminates leaks or drips that you may have had with the old faucet. It also enhances the look of your sinks. The guide below shows you how. Step 1 – Turn off Water Supply Turn off the water supply to the sink. Shutoff valves are usually found beneath the sink. Older houses are less likely to have shutoff valves. Should this be the case, youíll must turn off the main shutoff valve at the point of entry into the house. The valve might be found outside. Trace the cold water pipe until you find a socket marked with ìWî. Use a socket wrench to turn off the water. Step 2 – Clear Underneath the Sink Sacramento Plumbing Youíre likely to have stuff in storage in the area beneath sink. It is a good idea to put these items somewhere else temporarily. This will allow you to work efficiently. Step 3 – Light Up Sacramento Plumbing Place a portable light fixture or drop light in the area beneath the sink. You’ll need lots of light to enable you to work efficiently. Step 4 – Disconnect the Faucet You will find 2 big tubular screws at the rear of the sink that secure the faucet against the sink. Water supply tubes run through these nuts. Use a basin wrench to loosen the nuts on the faucet. If your faucet has a spray head and hose, remove the screw that secures the hose. While you disengage the water supply tubes from the faucet, water will drain back from the faucet. Soak up the water using an old towel. Stand at the sink and lift up the detached faucet out of the sink. Put it aside. Step 5 – Clean Sacramento Plumber Dirt is likely to have build up where the faucet was mounted to the sink. Remove the dirt using a putty knife. Wipe the area clean with a slightly wet cloth. For stubborn particles, use some white vinegar to remove stains. Step 6 – Install New Faucet Apply some plumberís putty around the faucet base if it wasnít supplied with gaskets. If the new faucet has a squirt head, run the hose through the allowance on the faucet, then through the sink. Attach to the supply stub. Install the faucet to the sink. Attach nuts and tighten partially by hand. Examine the faucet to see whether it’s properly aligned. If gaskets are used, ensure theyíre also properly aligned. You can then proceed to tighten the nuts completely with the basin wrench. Step 7 – Inspect Turn on the water supply. If you notice leaks, youíll need...

Read More »