I contacted Mr Rooter to give me an estimate on a new tankless water heater I was looking for. Trevor came out, and he was the nicest guy and we went over all the details and information, and he told me he would give me quotes on two different systems, and I never got the quote on the second system. Their office followed up a couple times, and i had to ask for the model number for the Rinnai they were going to use, and i got all of that. I got the estimate from Tracie Hawkins in their office and i responded back to her e mail, the same day, asking for them to give me another estimate with the same Rinnai Water heater that i had been quoted with from other installers, and she never responded. Its almost a month later and I still have not heard back. I recommend that you try other plumbers if your going to be doing a large project. This was a $6000 plus project, i would have thought they might have had a little more interest in getting the job.
My water heater thermostat pilot kept going out. After Gary replaced it with a new one, it continued to go out. Gary kept calling to check and came over a few times until he could figure out what the problem was. Happy to report, my water heater finally continues to work. Gary also called a week later to check that it was still working. I recommend Neighborhood Plumber.
I had sewer back up problem and called Mr. Rooter on Sunday. One George arrived at scheduled time. Explained about snaking and hydro jetting. Scheduled service for Monday noon as it was already dark. George called and came ahead of schedule at around 10.40AM. Tried Hydro-jetting as well as snaking. Removed lots and lots of roots, but still could not open up the drain. His supervisor came and located the blockage which was very close to the city sewer line. Actually, the sewer line belongs to the county and he was not able to give an accurate estimate until he calls the county office and finds out their regulations etc. But, he did mention that couple of large trees need to be cut down, need to dig down and replace the broken (not sure how it was concluded, experience may be - will give him benefit of doubt) clay pipes with PVC and the cost will easily run upwards of 10K!!