Also known as a drain auger, a drain snake is a coiled device around ¼-inch thick. To use a drain snake, put the end into the entrance of the drain. Turn the handle to force the snake deeper, using extra pressure to force it through the bend in the pipe. Keep turning until the snake hits the clog, then either pull the snake and remove the obstruction or force it through. Once the snake is out of the drain, run the water on full blast for a few minutes to ensure the obstruction is completely removed.
Had my master bath toilet replaced, as I was told it may still have problems if repaired. The plumbers had to leave and go buy a new toilet and then come and instal it. The first quote was 540.00 to repair, or 977.00 to replace. Both were OUTRAGEOUS. After asking to talk to the manager, the instal price was 775.00. Still very high, but better. Would not recommend this company. At least its done.
I had sewer back up problem and called Mr. Rooter on Sunday. One George arrived at scheduled time. Explained about snaking and hydro jetting. Scheduled service for Monday noon as it was already dark. George called and came ahead of schedule at around 10.40AM. Tried Hydro-jetting as well as snaking. Removed lots and lots of roots, but still could not open up the drain. His supervisor came and located the blockage which was very close to the city sewer line. Actually, the sewer line belongs to the county and he was not able to give an accurate estimate until he calls the county office and finds out their regulations etc. But, he did mention that couple of large trees need to be cut down, need to dig down and replace the broken (not sure how it was concluded, experience may be - will give him benefit of doubt) clay pipes with PVC and the cost will easily run upwards of 10K!!
Plumbing Service Co