We called Mr. Rooter because our water wasn't draining properly and a neighbor said that we needed a new grinder/sewage pump. We told them that we needed a 2 HP pump and they said ok but we had to pay half of the $2350 bill first. Unfortunately we were too trusting by paying the full bill instead. A guy came out with an industrial/commercial pump instead of residential. The plumber worked a full day trying to install it although it was obviously wrong because wiring was different. He finally gave up and called 3 other guys who came to help him for another few hrs. Finally the guy said he needed his supervisor to come because he was good with electronics. The next evening the supervisor came to tell us the store they bought it from had made the mistake but they could make it work with a $2500 control box! When he was told absolutely not he said there was nothing else they could do.
They came out to my house and I was explaining the situation and said he would have to snake the bathroom toilet, but it would be $ 653.00 just to remove it. I removed it in 3 minutes.  Then I showed him both clean traps,  And again I am removing a little bit a rock from around the clean traps outside.  I paid them for the work preformed and was to have them scope the line the next day , no show , no call. Boooo Bad Service . 2nd Time
Also known as a drain auger, a drain snake is a coiled device around ¼-inch thick. To use a drain snake, put the end into the entrance of the drain. Turn the handle to force the snake deeper, using extra pressure to force it through the bend in the pipe. Keep turning until the snake hits the clog, then either pull the snake and remove the obstruction or force it through. Once the snake is out of the drain, run the water on full blast for a few minutes to ensure the obstruction is completely removed.
Before calling a plumber, try to unclog your drains and toilets yourself by using a plunger. Make sure you use a standard bell-shaped plunger for your sink and shower drains and a plunger with a flanged end for your toilets. If neither type can loosen the pipe blockage, put a plumber's snake to use. Ratchet the snake down the pipe to eliminate any clogs.
Sometimes a faucet leak can be stopped by replacing the rubber washer at the end of a faucet stem or cartridge.  This is a more common repair on older fixtures when things were built to last and designed to be able to be maintained.  Other times the whole stem or cartridge needs replacement or the bibb seat deeper back into the fixture needs replacement.  That leads to matching up the right components and often times making a trip to the hardware store or plumbing supply house necessary due to the many varieties, makes and models of faucets.  My advice is to make sure your Plumber has faucet repair kit on their truck before having them come out to assess the issue.

Plumbing Service

×